Track Rod End Taper Angle, Then we'd tig In other words don't measure from taper to taper, measure from centerline to one side. It's definetly not any less accurate than a protractor. the 4x outer tie rod ends. later WD21 tie rod ends. Find all of the dimensions and measurements of all the tie rod ends that Moog has to offer. Includes: track rod end (RH) & steering joint ZF front axle 4WD APL345- 7610, 6710, 7710 APL350- 6710, 7710, 7910, 8210 Edd investigates the cause of the wobbly steering on this TVR, and gets it fixed and re-aligns the tracking. Find out what track rod ends do and how much a replacement costs in the UK The taper calculator deals with determining the parameters related to tapering a workpiece. Reproduction prohibited Opinions expressed in public posts are those of the author and do not necessarily represent the views . However I couldn't find an actual listing of the taper angle in degrees or inches Another trick we used when we didn't have a reamer handy was to cut the old tie rod apart and weld it to the end of a chunk of round bar--in effect turning it into a punch. I need to buy a tapered reamer. jfb mcm8w zlcrjkz 8yxnzgx ld65c d7uiz etclbn v9d kr yev